Blog #180*6*22mm metal grinding disc

Can a machine be installed with a variety of sizes of grinding discs? Such as 180*6*22mm metal grinding disc.

The description of the speed of the work of cutting machine grinding disc is often caused by the cutting table to describe the work faster than 5.5KW, the speed of 2800 rev / min, cut off the workpiece diameter.

The reason is that the torque is large when the cutting is performed, and the damage of the grinding wheel of the cemented carbide is also relatively large, so it is suggested that the grinding disc should have a certain rigidity, and we often use the 180*6*22mm metal grinding disc with a thickness of 3.8 mm.

At the same time, due to the large diameter of the cutting, the resistance of the grinding disc will also increase, and the temperature of the new surface will be high, so it will be very important to lower the cutting temperature. Conditions like this, the temperature of the added water should be reduced when cutting.

Green silicon carbide 180*6*22mm metal grinding disc can be divided into flat grinding wheel, bevel grinding wheel, cylindrical grinding wheel, cup grinding wheel, disc grinding wheel, etc. According to the shape, it can be divided into ceramic grinding wheel, resin grinding wheel, rubber grinding wheel, metal grinding wheel and so on.

The characteristic parameters of 180*6*22mm metal grinding disc are abrasive, viscosity, hardness, binder, shape and size. Because grinding wheels usually work at high speeds, they should be tested before use for rotation (to ensure that the wheel does not break at working speed) and static balance (to prevent machine tool vibration when working). After grinding for a period of time, the grinding wheel should be trimmed to restore the grinding performance and the correct geometry.

It is forbidden to install the grinding machine in a place facing the nearby equipment and operators or where people often pass. A special grinding machine room should be set up in a general large workshop. When the grinding wheel is found to be unbalanced after being repaired or repaired, it should be repeated for static balance. When grinding the workpiece with a 180*6*22mm metal grinding disc machine, the operator should stand on the side of the grinding wheel and not operate on the front of the grinding wheel, so as to avoid grinding wheel flying out or grinding wheel breaking out and hurting people. In addition, if cracks are found in the local grinding wheel, it should immediately stop using, replacing the new grinding wheel, in order to avoid the 180*6*22mm metal grinding disc breakage injury accident.