Green silicon carbide 180*6*22mm metal grinding disc can be divided into flat grinding wheel, bevel grinding wheel, cylindrical grinding wheel, cup grinding wheel, disc grinding wheel, etc. According to the shape, it can be divided into ceramic grinding wheel, resin grinding wheel, rubber grinding wheel, metal grinding wheel and so on.
The characteristic parameters of 180*6*22mm metal grinding disc are abrasive, viscosity, hardness, binder, shape and size. Because grinding wheels usually work at high speeds, they should be tested before use for rotation (to ensure that the wheel does not break at working speed) and static balance (to prevent machine tool vibration when working). After grinding for a period of time, the grinding wheel should be trimmed to restore the grinding performance and the correct geometry.
It is forbidden to install the grinding machine in a place facing the nearby equipment and operators or where people often pass. A special grinding machine room should be set up in a general large workshop. When the grinding wheel is found to be unbalanced after being repaired or repaired, it should be repeated for static balance. When grinding the workpiece with a 180*6*22mm metal grinding disc machine, the operator should stand on the side of the grinding wheel and not operate on the front of the grinding wheel, so as to avoid grinding wheel flying out or grinding wheel breaking out and hurting people. In addition, if cracks are found in the local grinding wheel, it should immediately stop using, replacing the new grinding wheel, in order to avoid the 180*6*22mm metal grinding disc breakage injury accident.
