Side grinding problem
In the daily use of the grinder, we often find that some operators do not divide the type of grinder, regardless of the type of fast 9” grinding wheel, and use the side of the grinding wheel to grind it arbitrarily. This is a serious violation of the safety operation rules. behavior. According to the regulations, the grinding wheel with the circumferential surface as the working surface should not be grounded. The radial strength of the grinding wheel made in China is large and the axial strength is very small. When the operator is too strong, the grinding wheel will be broken and even hurt. In practice This behavior should be prohibited during use.
Positive operation problem
In daily use, many operators are always accustomed to working on the grinding wheel made in China because the direction can be used. In fact, this behavior is a special prohibition in the operation of the grinder. According to the operating procedure, when grinding the workpiece with a grinder, the operator should stand on the side of the fast 9” grinding wheel and must not operate on the front side of the grinding wheel to avoid the grinding wheel flying out or the grinding wheel breaking out and injuring people when the grinding wheel fails.
Hard operation problem
In the use of grinders, some operators, especially younger operators, are trying to grind quickly and use too much force, which is a very unsafe operation. The flatness of any grinding wheel made in China has a certain strength, which is likely to cause the fast 9” grinding wheel to break, or even fly out and hurt people, it is also a behavior that should be prohibited.
